Results 1 to 2 of 2
08-03-2011, 11:01 PM #1
- Join Date
- Aug 2011
2002 2500hd 4x4... rotor question.
Was wondering if anyone knows the size of bolt used for pressing the rotors off of the hub.... went thru my misc bolts and do not have one so will have to go purchase. Any help would be great thx.
08-03-2011, 11:10 PM #2
I dont know the bolt size. Front or rear? if its the rear make sure the ebrake shoes arent sticking or in a groove. then you can try a sledge on the cast iron part around the hub to try and break loose any rust. or a dead blow hammer can be used on the rotor.David
2004 Silverado 2500 Crew Cab 4x4, AMSOIL EA air filter, Granatelli MAF sensor, Throttle body spacer, Magnaflow exhaust (true dual to 2 in 1 out muffler), 6" ProComp lift (add a leaf and 5" superlift rear block), Bilstein shocks, 35's (Cooper Disoverer ST) and 4.10 gears, Rhino Liner, EGRUSA fender Flares and widow visors, extended stainless steel brake lines, firestone airbags w/onboard air compressor, Pioneer Avic X940BT navigation, Accel backup camera.
1960 Land Rover Series II 88
2001 Pontiac Sunfire
2013 Toyota Avalon Limited (Wife's Car)
NRA Life Member
By ChevyFan in forum Chevy Trucks For Sale eBayReplies: 0Last: 01-20-2011, 04:40 PM
By rolltideroll in forum Chevy Silverado Forum (GMC Sierra)Replies: 1Last: 05-23-2010, 04:47 PM
By mtn_sierra in forum Lifted & Offroad SuspensionReplies: 0Last: 05-11-2010, 03:10 PM
By derekj in forum Chevy Silverado Forum (GMC Sierra)Replies: 3Last: 12-01-2009, 11:10 PM
By aquaholic in forum Chevy Avalanche Forum (Escalade EXT)Replies: 3Last: 10-06-2008, 04:34 PM
Tags for this Thread