Results 1 to 2 of 2
Thread: play in NV246 output
07-16-2011, 01:09 PM #1
play in NV246 output
I was just under the Suburban checking the drivetrain and I'm getting some up and down play in the transfer case rear output. With the wiggle is a "clink" coming from inside the transfer case.
To start: how much (if any) play is allowed in the rear output bearing?
Can the bearing be replaced without rebuilding the entire transfer case?
Last edited by MrShorty; 07-16-2011 at 01:10 PM. Reason: specify rear output'98 K1500 Suburban LS 5.7 L 4L60E NV246 ARB
'92 Ford Explorer XLT 4x4 4.0 L A4LD BW13-54 Trac-loc rear
"My toys were the greasy cogs and springs and pistons that lay around all over the place, and these, I can promise you, were far more fun to play with than most of the plastic rubbish children are given nowadays." Danny in Roald Dahl's Danny The Champion of the World
07-21-2011, 10:19 PM #2
Decided to get a 2nd opinion. The shop I took it to agreed that the output is getting loose. They said there is a bushing on these that is usually what wears out. They want quite a bit to change it, because they need to split the case to get to it.
By Highside in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last: 04-11-2011, 02:42 PM
By irbya in forum Audio & Video ClassifiedsReplies: 0Last: 08-28-2010, 06:15 PM
By MWright936 in forum Audio, Video & Gadget TechReplies: 7Last: 05-22-2009, 09:11 AM
By thejms in forum GM PowertrainReplies: 5Last: 05-09-2009, 02:05 PM
By MrShorty in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last: 09-28-2006, 07:35 PM
Tags for this Thread