Results 1 to 4 of 4
08-02-2011, 11:07 AM #1
High stall converter VS gear change
Looking for better acceleration from stopped or low speed for towing or just being heavily loaded. It occurs to me I could just change the torque converter to a higher stall speed and get the engine into it's power band quicker and still have the bennifits of a road gear with lock up and over drive still intact. I suppose around town driving might not be as good but I don't know. I have not seen this suggested or discussed as an alternative to lowering the gear ratio for improved low end acceleration and am looking for the pros and cons of doing this.
What are your thoughts?2000 GMC YUKON SLT, 5.3L tow pkg, G80 rear/w 3.73 gear
08-02-2011, 11:12 AM #2
I would go with the torque converter. I like YankConverters.:cool:
2005 Chevy Silverado Z71 Crew Cab
6" Skyjacker lift w/Edlebrock dual front remote resoviour shocks, single rear remote. Rancho skid-plate.
17" x 9" M/T Classic Lock Wheels, 35" BFG A/T or M/T tires
4.10 PercisionGears w/factory locker, T/A Performance rear-end cover
Banks CAI intake, ported throttlebody, JBA coated headers, over-sized Magnaflow cats, Magnaflow cat back exhaust, Diablo tuned
B&M aluminum deep transmission pan
Warn brush guard w/Warn 9.5 XP winch, PIAA bulbs, Line-X bedliner, AWS Black tool chest, Extang tonneau cover
Weather Tech floor mats
Cover-Craft seat covers
Dash mat cover
Formula One window tint
One black Lab in rear seat.
08-02-2011, 12:07 PM #3
- Join Date
- Sep 2010
- Far West, Oregon USA,
- Blog Entries
Yep it will work & you won't really need to worry about driving around town as long as you're not throttling it heavy. If you accelerate easy it will engage at lower RPMs around town. It's only when you mat the gas that it freewinds to the stall speed & then hooks. B & M & TCI also make good convertors1988 Chevy C-3500 2wd (no pic)
350 c.i. 5.7 L Stock Block, 4 Bolt Mains
L-31 Vortec Heads, Edelbrock Cam & Intake,
Holley 650, Flowtech Headers, Magnaflow exh.
Jet Trans 700R4, B&M Ratchet, 4:10 gears,
3" susp. lift kit "shadetree"
No rev limiter, No speed limiter lol
08-02-2011, 12:40 PM #4
Those were some of my thoughts also and maybe even a better choice than a gear change in most cases. May post this question in a transmision forum to see what comments I get.
By jason778 in forum GM PowertrainReplies: 7Last: 11-29-2010, 07:44 AM
By jamesdeanj in forum Chevy Silverado Forum (GMC Sierra)Replies: 3Last: 05-27-2010, 04:25 PM
By Twiztidss in forum General ClassifiedsReplies: 0Last: 12-02-2009, 04:12 PM
By ccmnova in forum Chevy Silverado Forum (GMC Sierra)Replies: 4Last: 07-21-2009, 09:34 AM
By beenurman in forum GM PowertrainReplies: 6Last: 05-30-2009, 02:04 AM
Tags for this Thread