Results 1 to 10 of 21
Thread: Rear Springs
08-24-2007, 04:46 PM #1
Any body thought of putting H2 Hummer springs in the rear of their 00 and up Suburban. I just towed a 6x12 UHaul to Monterey from the LA area and even though I have Autoride on my 00 Suburban the rear was pretty low. I was thinking about heavier rear springs and wondered about H2 springs. I do not want to lift it too far but do not want a lot of sag when I tow or have 6 people and gear in it either. Those poor rear autoride shocks got a workout man! I run 285/75x16 tires on stock 2004 wheels. Minimal trimming of the wheel well plastic and they work just fine. Does Moog make cargo coils for this application? I have a co-worker with an H2 and am going to check out his rear springs next week (wire diameter and height). Just thought I would ask if anybody has done this.
08-24-2007, 08:16 PM #2There is no way to happiness....happiness is the way.:yipi:
High Desert SoCal
93 K1500 burb (personal) 350 AT 3" Lift 250K+
02 Honda Civic LX
Looking for a 1990's Miata for an engine swap
08-26-2007, 09:27 PM #3
The only thing they show for coils springs is for a Crown Victoria.
08-28-2007, 08:26 AM #4
Ahh, if you have autoride (shocks & coil springs), things do get a bit more tricky. I'm sure you can replace the springs, but it might mess with the autoride system. I know people have put a whole new non-autoride suspensions in there and just disable autoride, but you would like get a DIC message everytime you turn on the vehicle. Which I'm guessing could also be turned off via a custom PCM tune.
I'd call a few places that sell/install suspension components for our trucks and see what their experience is with autoride.
2009 GMC Sierra Denali AWD
08-29-2007, 01:28 AM #5
I only want to lift an inch or 2. Autoride on mine kicks in when the car is loaded and needs to come back to level, so if was level with weight in it (due to heavier springs) the autoride would kick in less.
10-04-2007, 11:06 PM #6
Just to update the H2 springs have a larger wire diameter, but same outside circumference as the suburban springs but are 1.5 inches taller. As soon as I locate a set I am going to try them out. I've talked to a couple 4x4 shops and when they do a lift on an H2 they will call me to pick up the stock springs.
10-07-2008, 06:48 PM #7
I did it!
Just so you all know, I looked for used H2 springs for a year and could not find any. So I broke down and bought a new set. Today I installed them. I took some measurements but the pictures did not turn out well of the tape measure. Overall I gained an inch and a half to two inches of ride height. We will see when they settle down what the total is.
Picture 1 Stock height
Picture 2 New springs
Picture 3 Spring difference
Picture 4 How it looks on the street
10-07-2008, 07:32 PM #8
- Join Date
- Nov 2006
- Canyon Lake, Texas
- Blog Entries
Looks like you came out well. Has it caused any problems with the auto ride?
2010 Z/71 Colorado C/C
Black 4X4 w/5.3L V8
2007 Winnebago Adventurer
w/8.1L Chevy & Allison 6spd.
Canyon Lake, Texas
10-07-2008, 07:56 PM #9
Get some of those air bag things, or you could add a leaf. It raises up the back 2 inches though.2006 Silverado Z71 - 97,000 - totaled, RIP
2006 Silverado Z71 - 122,000 (K&N 77 Series CAI, PowerAid TBS, Magnaflow dual rear exit, 33x12.50 Mickey Thompson MTZ, Tuff Country Torsion Keys, Tuff Country Add-A-Leafs)
1966 C10 swb stepside (Gen I 350, Turbo 400 trans, dual cyl power brakes, front discs)
I'll keep my money, guns, and freedom. You keep the Change.
10-07-2008, 09:11 PM #10
By michiganhunter in forum Chevy Silverado Forum (GMC Sierra)Replies: 0Last Post: 06-29-2010, 06:41 AM
By silvertruck in forum Lifted & Offroad SuspensionReplies: 9Last Post: 05-17-2010, 01:02 PM
By altheflip in forum Lifted & Offroad SuspensionReplies: 2Last Post: 06-18-2009, 10:26 AM
By vncj96 in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last Post: 04-20-2009, 12:29 PM
By Chevy02Burban in forum Lifted & Offroad SuspensionReplies: 12Last Post: 04-11-2009, 09:36 AM
Tags for this Thread