Results 1 to 3 of 3
Thread: Special Tool Required?
09-18-2011, 05:32 AM #1
Special Tool Required?
I am pulling the Front Axels out on my 1990 Suburban 2500.The Nut on the Hub appears to require a special Socket?Someone has damaged this Nut in the Past,thats why I wondered if it needed some kind of Spindle Socket?
I live in Norway,so any special bits for American Cars are not easy to find.Does anyone have any ideas of what else I can use to take the Nut off?
09-18-2011, 06:22 AM #2
SHad a whole thing written up for you, then remembered you have a solid front axle. Yes, you do need a very special socket for those. Something like this..
- OEM Automotive tools - Built by GreatNeck » OEM 1/2 Inch Drive Front Wheel Bearing Locknut Socket
Just went out to the garage. Mine is a KD 2467. 60 mm outer diameter. It works, but it doesn't have the nice outer retaining ring.
Last edited by 2COR517; 09-18-2011 at 07:18 AM.When you hear hoofbeats, look for horses not zebras.
09-18-2011, 07:43 AM #3
By tidyupthegarage in forum Lifted & Offroad SuspensionReplies: 10Last Post: 05-01-2011, 11:07 AM
By a564jim in forum GM PowertrainReplies: 0Last Post: 08-12-2010, 09:22 AM
By drwdominance in forum Performance & FuelReplies: 10Last Post: 05-05-2010, 06:38 AM
By Mike Hill in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last Post: 08-23-2009, 04:59 PM
By safetyfast in forum General Chevy & GM Tech QuestionsReplies: 6Last Post: 06-05-2009, 10:06 PM
Tags for this Thread