Results 1 to 5 of 5
09-24-2011, 01:40 PM #1
King Pin Play,how do I reduce it?
Apologies if I have the terminology wrong for this part.I have play in the front right Hub on my 1990 Suburban 6.2D.
I was told that to adjust the play in the "King Pin" I was to slacken the Nut off and Beat on the side of the Ear indicated.This I have done,after retightening the Nut,the slack remains.
Perhaps my beatings arn't man enough?
09-26-2011, 02:50 AM #2
You don't have kingpins. The only GM truck of that era that had kingpins were 1 ton solid axle trucks that had a Dana 60. Looking at the pic, your truck has a GM 10 bolt that uses upper and lower ball-joints. There is no adjustment if the ball-joint has any play it has to be replaced. FYI, if you had kingpins wacking the ear with a hammer will do nothing to adjust them. They need to be taken apart and inspected for wear then rebuilt or shimmed.
97 Chevrolet Suburban K1500 5.7L
78 GMC High Sierra K1500
Fat, drunk, and stupid is no way to go thru life.
09-27-2011, 09:34 AM #3
Thankyou for your reply.I bought two new lower Ball joints because I wished to replace them when I removed the Front Axels to replace the Universal Joints.How do I get the top ball joints out?
09-28-2011, 03:02 AM #4
They are pressed into the knuckle. Rent or borrow a ball-joint press and push them out. I use a propane torch to heat up the knuckle. You don't need to get it red hot just warm it up, it'll make the metal expand slightly. The job will be alot easier.
09-29-2011, 08:14 AM #5
By tigersdl65 in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 11-08-2010, 12:23 AM
By 22inSilverado in forum GM PowertrainReplies: 15Last Post: 04-21-2009, 04:43 PM
By jackie in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)Replies: 3Last Post: 02-21-2008, 10:43 AM
By grantahoe in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)Replies: 2Last Post: 01-14-2008, 02:57 AM