GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 3 of 3
  1. #1

    Default Another keyless remote - 2001 Suburban

    I found directions about a year ago, and now I can't find any. I would be grateful if someone who does know would be willing to help me out. 2001 Suburban.

    Thanks!!!

  2. #2
    Moderator

    dwill3015's Avatar
    Join Date
    Jan 2007
    Location
    Yacolt, Washington
    Posts
    4,338
    Blog Entries
    2

    Default

    Welcome to the site, Hope this helps...

    Transmitter Programming

    Important
    All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to four transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.


    You may program up to 4 transmitters, using either of the two following procedures:

    Transmitter Programming Procedure (Method 1 - No Tools Required)
    Close all the vehicle doors.
    Insert the ignition key into the ignition lock cylinder.
    Press and hold the door unlock switch.
    While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
    Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
    Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
    Repeat the previous step to program up to four transmitters.
    Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter mode.
    Operate the transmitter functions in order to verify correct system operation.
    Transmitter Programming Procedure (Method 2 - Scan Tool Required)
    Install a scan tool.
    Turn the ignition ON, with the engine OFF.
    Use the scan tool in order to access the Body Control Module (BCM) Special Function: Program Key Fobs menu.
    Follow the directions on the scan tool in order to program the transmitters.
    Operate the transmitter functions in order to verify correct system operation.
    Darcy
    Washington State
    2006 Silverado 2500HD LT3 4X4 CC SB Duramax LBZ
    Tuff Country 6" lift, 35" Toyo M/T's on 20" Ultra Peacemaker wheels, Quadzilla Stealth2 programmer, Diamond Eye 5" cat-back exhaust, factory Special order color Yellow.

  3. #3

    Default

    ok i read all the programing instructions, and nothing happened the door lock and then unlock. If I hold the buttons down for a long time nothinghappens. I took the remote to the dealer and had it tested(free) they said it was transmitting a signal. Is there a fuse or an antenna or something thatmay be unplugged? I really do not feel like spending $50 . if I don't need too. The truck is a 2000 Silverado

Similar Threads

  1. 2000 2001 chevy gmc suburban keyless entry remote fob n
    By ChevyFan in forum Chevy Keyless Entry Remotes
    Replies: 0
    Last: 08-16-2009, 04:21 AM
  2. 2000 2001 chevy gmc suburban keyless entry remote fob n
    By ChevyFan in forum Chevy Keyless Entry Remotes
    Replies: 0
    Last: 08-02-2009, 02:10 PM
  3. 2001 2002 chevy tahoe s-10 keyless entry remote key fob
    By ChevyFan in forum Chevy Keyless Entry Remotes
    Replies: 0
    Last: 06-26-2009, 07:00 AM
  4. 2001 2002 01 02 chevy impala key + keyless entry remote
    By ChevyFan in forum Chevy Keyless Entry Remotes
    Replies: 0
    Last: 06-26-2009, 07:00 AM
  5. 2000 2001 chevy gmc suburban keyless entry remote fob n
    By ChevyFan in forum Chevy Keyless Entry Remotes
    Replies: 0
    Last: 06-15-2009, 05:20 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •