Results 1 to 5 of 5
10-01-2011, 10:19 PM #1
- Join Date
- Oct 2011
10-02-2011, 02:10 AM #2
- Join Date
- Dec 2004
- Arlington, Texas, United States
- Blog Entries
What's your Year/Make/Model for your truck?
10 Chevy Traverse LT AWD
02 Chevy Trailblazer LS (110K+ miles - loaded except for 4WD - WRECKED!)
99 Chevy Cavalier LS (105K+ miles - commuter car)
78 Chevy Suburban Silverado (454, 3/4 ton)
62 GMC 3/4 ton Pickup (350 police interceptor)
Remember: Search Before Posting | Fill out Your Profile & Signature
* I've been saying for years that I was going to change my username, and I finally did.
10-02-2011, 08:27 AM #3
As mentioned above by Steve......we need to know what Year and Model Truck you have......a 5/8 Drop Means the Truck have been Lower/Dropped 5ins" in the Front and Lower/Dropped 8ins" in the Rear.......and as far as what Company'S(Good).......Bell-Tech.....Eibach......DJM......Ground Force are some of the ones to look at......keep in mind that dropping any Truck that Low.....will Cost a Good Chunk of $$$$.....
Truck Lowering Kits At StylinTrucks.Com
5.3 l 3.73 l G80
BLACK BEAR CUSTOM TUNE
SNUGTOP l COLORMATCH l KATZKIN
11-18-2011, 02:40 AM #4
Best bet for you is drop knuckles with smaller coil springs for the front and drop hangers and shackles for the rear
11-28-2011, 01:12 PM #5
I know this is a older thread, but you'll need 2" lowering Spindles, and 2" coils cut an inch for the front. Or 3" coils if you can find them. For the back you'll need a c-notch, 6" flip kit, and lowering shackles. That'll give you a 5/8. Belltech or Mcgaughys are the companies I'd order from. People have way too many problems with DJM.Bagged 06 Silverado Crew Cab.
By JennaBear in forum Chevy Trailblazer Forum (GMC Envoy)Replies: 4Last: 03-19-2010, 12:45 PM
By jstiene in forum Performance & FuelReplies: 5Last: 01-23-2010, 10:46 PM
By 2010SSRS in forum General Chevy & GM Tech QuestionsReplies: 0Last: 12-18-2009, 01:33 PM
By 9191gmc in forum Chevy Silverado Forum (GMC Sierra)Replies: 6Last: 07-29-2009, 08:22 PM
By lecktroman in forum Member IntroductionsReplies: 7Last: 05-30-2008, 01:08 AM
Tags for this Thread