Results 1 to 6 of 6
11-16-2011, 11:42 PM #1
Wiper motor buzz - wipers die - 98 K1500
98 GMC K1500 - wipers will quit randomly, usually late at night in a downpour on some busy highway or a backroad in the dead of night, and the motor/control panel under hood gives off a light buzzing noise. At first I could just give the wipers a wiggle and they'd start up again. Now I have resorted to going under the hood and wiggling the wiring harness at the wiper motor to get them to kick in. Seems to be getting worse and worse. When they do come on they're fine. I took it apart and cleaned the connections but they looked fine. There was a ton of red grease on the round ring thing that the relay points ride on but it was clean.
I'm doubting it's the motor itself - maybe the control module?? Or delay circuit thing. Anyone else ran into this problem?-Berg
1998 GMC Sierra 1500 Ext Cab 4x4
11-17-2011, 07:02 AM #2
- Join Date
- Oct 2011
- Central Ohio
Sounds exactly like the control module. I've got a '95 C1500 and this happened when it was about 5 yrs old and the problem wasn't widely known yet. A wiggle would fire them right off most of the time. After it got worse, I put a rebuilt wiper moter on it with the control board included and it was fine for about the next 8-9 years. Started doing it again last winter and had the same symptoms you not working and buzzing noise. At first I could wiggle them and they would work, then it got to where I had to hit the panel on the wiper motor and they would start. I put in a new board last summer (only about $30 and maybe 15min) and its working beautiful.
I also had the same thing you mention about the grease being everywhere on the inside. I'm not sure if its supposed to be that way or not. I cleaned up the grease around the board area and tried to 'contain' it to the screw that passed through the lower portion. I don't drive the truck a lot, maybe 500-1,000 miles a month but no problems in the last couple of months.
I'd pull the module, clean up the grease in there and put a new one in if it was mine.
11-17-2011, 09:02 AM #3
Thanks Seph - pretty much what I was thinking too but good to have some confirmation. Never really notice the wipers aren't working during the summer! I'm going to swap in a new module tonight and see if that will cure it.
11-19-2011, 12:44 PM #4
If you can solder, you can fix it yourself. Remove the circuit board and look for cracks in the solder where the connector is soldered to the board. Just re-melt the solder on those terminals and reinstall. Easy and cheap!
Good Luck and God Bless
11-20-2011, 02:07 PM #5
I bought a new circuit board, only $30 and always in stock as they said it's a pretty common problem. However wipers have been working just fine for the last few rainy days... Figures. Once I get a little extra time I may swap it out anyway so it doesn't decide to die again on the freeway during a downpour.
I can solder ok from my old days doing RC cars but I'd rather not mess with it!
11-20-2011, 04:35 PM #6
I've had two boards in my '96 "Burb, I now keep one in the shop because they ALWAYS go bad on a holiday weekend.:cool:
2005 Chevy Silverado Z71 Crew Cab
6" Skyjacker lift w/Edlebrock dual front remote resoviour shocks, single rear remote. Rancho skid-plate.
17" x 9" M/T Classic Lock Wheels, 35" BFG A/T or M/T tires
4.10 PercisionGears w/factory locker, T/A Performance rear-end cover
Banks CAI intake, ported throttlebody, JBA coated headers, over-sized Magnaflow cats, Magnaflow cat back exhaust, Diablo tuned
B&M aluminum deep transmission pan
Warn brush guard w/Warn 9.5 XP winch, PIAA bulbs, Line-X bedliner, AWS Black tool chest, Extang tonneau cover
Weather Tech floor mats
Cover-Craft seat covers
Dash mat cover
Formula One window tint
One black Lab in rear seat.
By Bigbomber in forum Chevy Uplander & GM Minivan ForumReplies: 1Last Post: 07-18-2011, 07:30 AM
By eagleye in forum Chevy C/K Truck ForumReplies: 3Last Post: 07-18-2011, 06:29 AM
By dmaves in forum General Chevy & GM Tech QuestionsReplies: 6Last Post: 09-07-2010, 05:42 PM
By 03 Black Sunshine in forum GM Electrical TechReplies: 2Last Post: 05-01-2010, 01:43 PM
By 95CTburb19 in forum GM PowertrainReplies: 2Last Post: 12-16-2007, 04:05 PM