my brake light stay on on my dash iv chcked almost everything electrical, brakes, fluid e brake and brake light switch and everything is good does anybody have any other sugestions the truck is a 90 1500


You didn't mention if your truck has abs brakes. Could be one of the sensor if you do have abs.
There is no way to happiness....happiness is the way.
High Desert SoCal
93 K1500 burb (personal) 350 AT 3" Lift 250K+
02 Honda Civic LX
Looking for a 1990's Miata for an engine swap
Christopher
1991 Chevy Suburban 1/2 ton 2WD w/ chevy SBC 350-3/4 ton drivetrain upgrade w/4.10 gears 194K miles
2005 Saturn ION-2 Stock 200K miles (In 6 years...ouch)
1982 Bronco, 1993 Bronco, 1971 M35A2 Deuce and a Half
There are 10 kinds of people, those who understand binary, and those who dont...




The 90 has rear ABS brakes. More than likely sensor issue. It was not as critical on a 90 when they fail. (Some people disconnect them)
But I would put effort in it IMO to repair properly for piece of mind.
Jamie
2007 Ford E250(Work van) (Ya, Ya, shut up!)
1996 GMC Sierra SLE 1500 5.7L/4L60E
http://www.thefundumpster.com
i found the problem its the combo valve that screws into the master cylinder and hooks into my rwal wiring harness the previous owners of the truck had it unpluged now correct me if im wrong but since thats the problem doesnt that mean its saying my front and rear brake pressure is diffrent if so couldnt i just bleed my brakes does this make sense
Bookmarks