Results 1 to 3 of 3
12-07-2011, 10:05 PM #1
1995 C1500 4.3 Programmer Chip Installation
I've been looking at putting a chip into my trucks ECM to gain a little more power and better gas millage. How hard would it be to put it in? I know you have to take your ECM out and put the new P-ROM chip in. Where could I get the right one and is it a difficult job to do? I only saw a stage 1 chip on eBay that was listed for about $150. The link is below, would that be one that would work with my truck?
1995 C1500 4.3L
Manual trans. 5spd.
JET TBI Spacer
Upgraded plug wires
Stage 1 Chip:
Thanks for your help all!1995 C1500 4.3L 2WD. JET TBI Spacer, JET stage 1 chip, 10mm Taylor custom wires, Pulstar Iridium Pulse Plugs.
260k miles and still going strong...
12-07-2011, 10:27 PM #2
- Join Date
- Apr 2009
- Kingston Springs Tennessee
If yours is like a 94 model then it is really easy. The ECM is located under a trap door in your glove box. You remove the factory chip and install the new eprom. I purchased my stage 2 chip at Motorvation. You can call them up and they will explain what you need and help you with installation information.
You gain a slight increase in power and the transmission shifts out a little stronger. It didn't help my gas mileage from what I can tell. I still only get between 12 - 15 mpg on a good day.
Here is their website for GM trucks, http://www.motorvation.tv/chips_gm_l...rucks_vans.htm
Last edited by pondfishr; 12-07-2011 at 10:29 PM.
12-08-2011, 05:41 PM #3
Myself would not chip it spend money not gain much if any. But everyone has a opinion.
By 2000chevysilveradoz71 in forum Performance & FuelReplies: 0Last Post: 03-13-2010, 08:01 PM
By Silverado1500 in forum Performance & FuelReplies: 7Last Post: 02-01-2010, 10:13 PM
By chrismx104 in forum Member IntroductionsReplies: 7Last Post: 12-02-2009, 08:52 PM
By snider30 in forum Performance & FuelReplies: 2Last Post: 09-21-2009, 06:40 AM
By josh02z71 in forum Performance & FuelReplies: 2Last Post: 05-11-2009, 01:21 AM
Tags for this Thread