GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 2 of 2
  1. #1

    Default How do you replace the starter in a 1994 S10 Blazer?

    Does anybody know how to get the starter out of a 94 s-10 blazer??

  2. #2

    Default

    moving this to the Chevy Blazer forum ...

    ---------- Post added at 01:40 PM ---------- Previous post was at 01:35 PM ----------

    I found this on one of the scraper sites that probably stole it from somewhere.


    REPLACING THE STARTER (take all of the required safety precautions necessary)

    Jack up the front passenger side and take off the tire. Pull up the flap so you can see the starter. Crawl under the truck (make sure that the front jacks are secure - if you are not sure how to do this, get help in this area), and looking up at the starter you will see it is attached by two bolts.

    Looking towards the front of the Blazer you will see two bracing rods coming from the front and bolted to the aluminum housing between the engine and transmission. The housing itself is secured by four bolts. Remove the bolts from where the rods attach, and the first three of the housing bolts, starting at the top near the starter and leaving the last bolt remaining in. You will then gently tug downward on the housing about 1/2 inch, using the remaining bolt as the pivot point. You will now remove the two bolts holding the starter itself.

    Going back to looking at the starter from the wheel well, you now need to detach the two wires going to the starter. Move the starter around a bit until you can see the nuts holding the wires on, and then detach the wires. You will need patience to take off the wires, and just as much when reattaching them later. It will be tight, but the starter can now be turned and removed. Just don't move the gear inside the starter or the flywheel and you should be able to bolt it right back in without worry.

    Reverse the procedure to re-install the starter.


    ---------- Post added at 01:43 PM ---------- Previous post was at 01:40 PM ----------

    Let us know if this helps you our or not @mightymo
    Last edited by Steve; 12-14-2011 at 01:42 PM.

    Steve
    10 Chevy Traverse LT AWD
    02 Chevy Trailblazer LS (110K+ miles - loaded except for 4WD - WRECKED!)
    99 Chevy Cavalier LS (105K+ miles - commuter car)
    78 Chevy Suburban Silverado (454, 3/4 ton)
    62 GMC 3/4 ton Pickup (350 police interceptor)

    Remember: Search Before Posting | Fill out Your Profile & Signature
    Follow Us Please: facebook.com/gmtruckclub | twitter.com/gmtruckclub
    Support GMTC: Help the site, contribute today

Similar Threads

  1. help, replace motor mounts 4.3 1994
    By werps in forum Chevy C/K Truck Forum
    Replies: 0
    Last Post: 10-02-2011, 10:56 AM
  2. 1994 Full Size 2 door Blazer
    By creamdubz in forum General Chevy & GM Tech Questions
    Replies: 2
    Last Post: 10-30-2010, 06:52 AM
  3. 1994 Suburban - Replace fuel pump?
    By R Runner in forum Performance & Fuel
    Replies: 5
    Last Post: 10-05-2010, 10:55 AM
  4. Replies: 0
    Last Post: 06-29-2007, 07:26 AM
  5. Replies: 0
    Last Post: 06-29-2007, 07:26 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •