Results 1 to 6 of 6
Thread: 98 Suburban 4wd question?
12-18-2011, 02:46 AM #1
98 Suburban 4wd question?
Just bought a 98 Suburban K1500 i have a question about the 4wd..The switch doesnt see to light in any postion,2wd,auto or 4hi or 4lo but seems to work,then sometimes the light does go on in 2wd drive only?...What causes this?...is there any way to fix this?....Thanks...1998 Chevy Suburban K1500
12-18-2011, 04:40 PM #2
Press hard around the switch site and see if they light up. A few of us have had loose contacts on the back side of the plugin.
.....ya clock faster and faster till the desire for speed overcomes the fear of bus.....
12-18-2011, 05:31 PM #3
12-19-2011, 10:42 AM #4
12-19-2011, 10:47 AM #5
Ok i will try pressing on the switch 1st then what else could it be if it doesnt go on? lite up?1998 Chevy Suburban K1500
12-19-2011, 11:13 AM #6
My switch works fine, but it has a hole in it. I think the previous owner always pushed on it too hard and broke through the lit up part of the switch, where the plastic is thinnest. I plan to find a new one and just swap it out. You should consider doing the same if it's not a loose connection. At least the 4WD works. A switch is a cheaper fix than a solenoid or a transfer case!I like you.
By Txflats in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 07-13-2010, 10:33 AM
By au5599 in forum GM PowertrainReplies: 1Last Post: 12-28-2009, 02:09 PM
By romangiberson in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 5Last Post: 07-31-2009, 08:27 AM
By romangiberson in forum Member IntroductionsReplies: 1Last Post: 07-28-2009, 11:13 AM
By westcoastjay in forum Lifted & Offroad SuspensionReplies: 6Last Post: 05-18-2009, 06:21 PM
Tags for this Thread