Results 1 to 5 of 5
Thread: camber kit
01-19-2012, 05:53 AM #1
I have a 1996 chevy cheyenne. When i crank my torsion bars up the out side of my tires chew right off. My question is can i just get away with doing a camber kit?
01-23-2012, 11:22 AM #2
01-24-2012, 04:28 PM #3
The camber kit is intended to allow the truck to be aligned. Actually, you have to knock the plugs out of the alignment slots in the frame before you put the kit in so you can adjust the alignment. It's not very hard to do, but you will need to get it aligned when you're done.
Good Luck and God Bless
01-25-2012, 11:09 AM #4
01-25-2012, 01:28 PM #5
the camber pins fell out when i did mine, i couldnt beleive it, never saw that before.
2003 GMC Sierra 1500 SLE 5.3
2.5 ReadyLift Leveling Kit
Low Profile Toolbox
Westin Nerf Steps
By livetoridemoto119 in forum Lifted & Offroad SuspensionReplies: 1Last: 01-23-2010, 09:29 PM
By mike1193 in forum Chevy C/K Truck ForumReplies: 3Last: 12-07-2009, 04:33 PM
By RATRODKING in forum Lifted & Offroad SuspensionReplies: 1Last: 10-30-2009, 03:02 PM
By ProjectJimmy in forum Lifted & Offroad SuspensionReplies: 5Last: 02-23-2009, 04:30 PM
By scottkh in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last: 07-16-2008, 10:13 AM
Tags for this Thread