Results 1 to 3 of 3
02-12-2012, 04:35 PM #1
Emergency brake pedal "pop" and stuck to the floor
This happened a few weeks ago, but as I was pushing the pedal to the floor...I heard a thud and the pedal went to the floor. I couldn't release the brake from the lever and the cable was still ok, didn't break.
The only way I could bring the pedal back up was to pull the release lever with one hand and lift the pedal with my other hand, then bungee cord the pedal in the up position.
What broke, a spring possibly? I don't know what the assembly looks like and I didn't see anything visually different when I looked under the dash near the pedal assembly.Matt
02-12-2012, 06:54 PM #2
What returns your e brake to the up position is the springs on the cables right on the backing plate (drums), or dust shield (rotors). So I will assume your e brake dosen't work anymore. Your cables run down the left side of the truck on the outside of the frame. Right around where the bed and cab meet, they split, and one goes to the right rear and the other goes to the left rear. One of your cables or both could be frozen and it pulled the cable out of the assembly or where the cables split the splitter bracket could of pulled out. Hope this helps good luck.
02-12-2012, 09:28 PM #3
hmmm I will have to look at that to see..I thought it would be something by the pedal, but that makes sense it's along the frame.Matt
By ross in forum General Chevy & GM Tech QuestionsReplies: 6Last Post: 05-20-2011, 07:15 AM
By mr24shoe in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 6Last Post: 11-30-2010, 09:44 PM
By cl buk in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 07-04-2010, 06:10 AM
By k.daddy1 in forum Lifted & Offroad SuspensionReplies: 8Last Post: 03-15-2010, 07:18 AM
By Mindi51982 in forum Lifted & Offroad SuspensionReplies: 22Last Post: 02-21-2009, 12:13 PM
Tags for this Thread