Results 1 to 1 of 1
Thread: Spare tire hoist tool update FYI
02-16-2012, 12:26 PM #1
- Join Date
- Jan 2012
Spare tire hoist tool update FYI
To provide update to my earlier thread (closed).
I mulled the idea of adding filler weld to the inside surfaces of that 1/2" square drive socket (that I had welded to the long rod).
I then hit upon the idea of trying a 7/16", 8-point socket to see if it would fit.
Pretty close but a bit too small to slip onto the male tool stem of the hoist.
I needed to "expand" the inside dimensions of the socket just a hair to get a tight fit.
To expand the socket, I selected a drift punch that miked out at about .040" bigger O.D. than the inside measurements of the socket.
I then heated the socket with a MAPP torch and drove the punch into the 8-point end of the socket.
Quenched the socket in oil.
The enlarged socket is a perfect match to the hoist stem.
Next I will fabricate an operating handle for the end of the rod that will be out away from the rear bumper when I use the hoist tools.
thanks to all who helped out with getting the necessary info for me to get along with this little project.
By Kan1ck in forum Chevy Silverado Forum (GMC Sierra)Replies: 9Last Post: 02-14-2012, 05:47 AM
By Steve in forum Chevy Parts eBayReplies: 0Last Post: 05-11-2011, 04:01 AM
By Steve in forum Chevy Parts eBayReplies: 0Last Post: 04-28-2011, 09:50 PM
By longrange223 in forum General Chevy & GM Tech QuestionsReplies: 5Last Post: 12-08-2010, 01:55 PM
By floridaron in forum Chevy Parts eBayReplies: 0Last Post: 08-25-2010, 10:04 AM