Results 1 to 1 of 1
Thread: Seat Swap
11-02-2007, 10:47 AM #1
- Join Date
- Feb 2007
- Burleson, Texas
- Blog Entries
I traded my 60/40 light pewter bench for a 60/40 dark pewter bench with the center console. I got them vacuumed out and cleaned up, but I still need to shampoo them real good one more time.
This was a relatively easy swap (or should have been).
I got the driver's side done in a snap. When I went to swap the passenger side, I noticed the plug in for the seatbelt/airbag wiring was different. At this point, I had two options. 1. I could swap the airbag sensor guts (I have an 07 with the bladder system and cpu mounted under the seat = lots of wiring). or 2. I could take off the covers and swap those, keeping the airbag system intact.
After looking at all that was involved with the airbag sensor, I decided to swap the covers. It wasn't too bad, but those bitches go on TIGHT. After a while, I got everything buttoned up and put back together. All in all, a pretty easy mod and I am way happier with the seats now! Now I have a reclining seat with lumbar support too...
Here is the old bench:
2007 Colorado Regular Cab Z85 2.9L/4 cyl.
18" Nissan Titan Rims
By Big Steu II in forum Chevy C/K Truck ForumReplies: 2Last Post: 09-19-2010, 06:03 PM
By itsabowtime2 in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 02-10-2010, 11:18 PM
By ColonialRovers in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 3Last Post: 09-15-2009, 09:16 AM
By jt_5.7 in forum General Chevy & GM Tech QuestionsReplies: 14Last Post: 08-30-2009, 02:23 AM
By rolly in forum Chevy C/K Truck ForumReplies: 2Last Post: 06-10-2009, 01:08 AM
Tags for this Thread