Results 1 to 2 of 2
03-01-2012, 11:07 AM #1
idea for a fix for the trucks that have a clunk in thier driveshaft
hello everyone, I have been reading alot about the vechiles that have a clunk in thier driveshafts due to the issue with the splines. I also seem to recall that I read somewhere that the driveshaft needs to be removed and clean and lubricate those splines. I have come up with a possible solution; I dont know if it would work or not, thats why I am running it by everyone here. My thought was to pull the driveshaft and the output shaft. Take them both to a machine shop and have a groove cut around the diameter of the output shaft, and then drill a hole and tap to fit a grease fitting on the driveshaft yoke in the same place that the groove was cut. I know it sound labor intensive; but only one time. After you could just put a couple squirts of grease in like every other oil change. this would in place of pulling out the driveshaft each time the splines have to be lubricated. Maybe I am way off base? any thoughts?
03-07-2012, 03:45 AM #2
- Join Date
- Feb 2008
- Cloquet, Minnesota, United States
- Blog Entries
That would work.. but there is a good chance that some of the clunk that you are hearing is play in the rearend as well. Just make sure that is the machine shop does it, that they ensure that there is a balance when they are done since you dont want to create a new vibration.Mike
1997 Chevy S-10 Blazer 4X4 with 330K miles and counting (Hunting rig).
2009 Saturn Aura XE (wifes car)
2011 F-150 Crew 4X4
"Hold it to the floor till you see God.... Then Brake!!!!"
By skinner in forum Lifted & Offroad SuspensionReplies: 116Last Post: Yesterday, 04:12 PM
By tnelson73 in forum Chevy Silverado Forum (GMC Sierra)Replies: 7Last Post: 01-02-2012, 05:23 PM
By ShadowRejects in forum Chevy C/K Truck ForumReplies: 6Last Post: 10-22-2011, 01:38 AM
By Steve in forum Chevy Trucks For Sale eBayReplies: 0Last Post: 12-23-2010, 07:10 PM
By tudorstyle in forum Chevy Silverado Forum (GMC Sierra)Replies: 2Last Post: 09-27-2010, 05:05 PM
Tags for this Thread