Front Bumper NNBS

**conroe** · 03-13-2012, 07:13 PM

This question is on the new body style front bumpers. The lower section were the tow hooks are. I have seen grills on ebay that go in this
area. What I am looking for is a solid panel that will give this area a smooth appearence. I want it to set flush with the rest of the cover.
Anyone seen where this can be had. Jerry

**sstoner911** · 03-13-2012, 07:38 PM

I have not seen and aftermarket part like your describing. What year is the truck?

**AMac** · 03-13-2012, 08:26 PM

If you are just looking for a solid piece maybe you can go down to a metal shop and they can fit one in for you.

**Untouchable** · 03-15-2012, 12:31 AM

I have a friend who did this. Remove the tow hooks, go to a metal shop just as @AMac says, and then weld it in on the back side...then just install the grill inserts...unless you're talking about somehow attaching the grill inserts to the metal.

**aloxdaddy99** · 03-15-2012, 03:14 AM

I have seen them on the Denali's but never on a Silverado. You could make them as suggested before and just zip srew them in.

**Jeremy09LTZCrew** · 03-28-2012, 12:17 AM

I know stylintrucks.com and autoanything.com have several inserts for that area. I'm not sure if they have anything like what you're looking for. You've probably already checked. Like others have said, there's always the fabrication route. I doubt it'd be a difficult job. You'd just have to see what it'd set you back.