Results 1 to 5 of 5
Thread: Battery spark question
03-21-2012, 07:41 PM #1
Battery spark question
My four year old battery finally gave up the ghost, I got a new one and when I disconnected the old one I noticed a slight spark. Got he same spark when I connected the new one, I hooked up my volt meter it showed about 1-1/2 volt draw. I started by pulling fuses and relays and watched it slowly trickle down to -0-, Hooked the batter post again, started it up the went through the drill again. Pulled the ground hooked up the meter and just watched it, about two minutes it did the same drop to -0-. Is it a norm to see the draw then leak down to -0-??
PhilHappy 2 Wheeler!
03-22-2012, 08:53 AM #2
Yeah, it's normal, but I am not sure about the voltage level, The computer (and security system, if you have one) needs a small constant charge to stay alive. I hope you are getting the spark from the neg cable. Of course you know to disconnect that one first, and connect it last, right.
03-22-2012, 07:27 PM #3
03-22-2012, 09:25 PM #4
i would say its normal, the BCM and other moduals need battery juice just after shut off. Some vehicles we have to wait half hour until we can do a draw test on the system
2003 Z71 Silverado LS
Access roll up cover
Billet Grill insert
CB with PA system
Waiting to be installed
Two 8in RF HX2 punch( would have 12s but they got stolen)
04-06-2012, 06:19 PM #5
By Goldie in forum Maintenance & UpkeepReplies: 9Last Post: 03-21-2013, 04:32 PM
By GMTC_Admin in forum Chevy Volt ForumReplies: 0Last Post: 12-09-2011, 02:30 PM
By 99monguse in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last Post: 10-25-2011, 08:49 AM
By bstrange99 in forum General Chevy & GM Tech QuestionsReplies: 0Last Post: 01-25-2009, 05:04 PM
By JOnNyAZ in forum Performance & FuelReplies: 6Last Post: 07-15-2008, 10:53 PM