Results 1 to 4 of 4
05-01-2012, 01:13 PM #1
fel-pro transmission pan gasket or factory
So I know that fel-pro is a well known name in gaskets. The typical cheap rubber gaskets you get with transmission filters are garbage, so my question is this.
Has anyone used the fel-pro trans pan gaskets with their fel-coprene? Or should I spend the extra and get the dealer oem rubber coated metal pan gasket.
felpro gasket. as always there is marketing spin with this but does anyone have experience with it.
2004 Silverado 2500 Crew Cab 4x4, AMSOIL EA air filter, Granatelli MAF sensor, Throttle body spacer, Magnaflow exhaust (true dual to 2 in 1 out muffler), 6" ProComp lift (add a leaf and 5" superlift rear block), Bilstein shocks, 35's (Cooper Disoverer ST) and 4.10 gears, Rhino Liner, EGRUSA fender Flares and widow visors, extended stainless steel brake lines, firestone airbags w/onboard air compressor, Pioneer Avic X940BT navigation, Accel backup camera.
1960 Land Rover Series II 88
2002 Nissan Altima (My Commuter)
2013 Toyota Avalon Limited (Wife's Car)
NRA Life Member
By Crazeetxn in forum General Chevy & GM Tech QuestionsReplies: 8Last Post: 07-17-2011, 09:31 AM
By sirchivalry in forum GM PowertrainReplies: 16Last Post: 02-26-2011, 04:14 PM
By phoebeisis in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 07-12-2009, 08:31 PM
By Steve in forum The Coffee Shop ~ Chit ChatReplies: 0Last Post: 06-08-2007, 11:53 AM
By Steve in forum The Coffee Shop ~ Chit ChatReplies: 0Last Post: 06-08-2007, 09:20 AM