Results 1 to 4 of 4
Thread: 4X4 problems
05-07-2012, 01:21 AM #1
I have an 89 chev k1500, 4X4, 5.7 auto. I just picked up this project. When I put it in 4wd, and drive foward a bit, the tires turn in. Mostly the right front. it puts the front end in a bind. I have to back up, and get it out of 4WD. Put it back in 2wd, and it drives great down the road.
I've never dealt with this before. Do you think the front and rear has different gear ratios? How can I find out what they are?Please Tell Your Boobs To Quit Staring At My Eyes
05-07-2012, 11:06 AM #2Do you think the front and rear has different gear ratios? How can I find out what they are?
Jack up both wheels on the axle.
Rotate the tires through one complete rotation, while counting the number of times the driveshaft rotates. This might be easier with a helper. Gear ratio=number of rotations of input (driveshaft)/number of rotations of output (tires).
Open diffs, worn out limited slips, and Gov-locks can allow one tire to rotate faster than the other. In order for the measurement to be accurate, both tires have to both go through one complete rotation. Sometimes I've left one wheel on the ground so it can't rotate. With one wheel in the air, that wheel will go through two rotations for every rotation of the carrier, which introduces a factor of 2 to the gear ratio calculation.
Not difficult and shouldn't take very long to do.
Alternatively, especially if you are going to open the diffs up anway, you can count the number of teeth on the ring gear and on the pinion gear. Gear ratio = teeth on ring gear/teeth on pinion gear.'98 K1500 Suburban LS 5.7 L 4L60E NV246 ARB
'92 Ford Explorer XLT 4x4 4.0 L A4LD BW13-54 Trac-loc rear
"My toys were the greasy cogs and springs and pistons that lay around all over the place, and these, I can promise you, were far more fun to play with than most of the plastic rubbish children are given nowadays." Danny in Roald Dahl's Danny The Champion of the World
05-07-2012, 05:27 PM #3
Cool man. Thanks for the info. The guy said he did get it rebuilt. I plan on adoing the SAC on the front anyways, but just screws with me now. lol
05-07-2012, 10:14 PM #4
- Join Date
- Sep 2011
- Center, TX
i know the older 4x4s have numbers stamped on the ring gear. take the smaller number and divide into the bigger number and it will give you your gear ratio.
By AnsteyZ71 in forum General Chevy & GM Tech QuestionsReplies: 2Last Post: 06-24-2010, 11:23 PM
By Silverado Junkie in forum GM PowertrainReplies: 35Last Post: 05-07-2010, 11:10 PM
By chevy 2500hd in forum Audio, Video & Gadget TechReplies: 8Last Post: 10-01-2008, 07:21 PM
By Kdogg05 in forum Announcements & FeedbackReplies: 2Last Post: 06-10-2008, 03:37 PM
By bidutch in forum GM PowertrainReplies: 3Last Post: 12-13-2007, 06:59 PM