Results 1 to 3 of 3
11-24-2007, 02:21 PM #1
Need some help with a serpentine belt
I've loosened the tensioner pulley bolt. I can see it's moved a little, but the belt is still tight. Is the tensioner supposed to rotate out of the way?
My Chilton's guide just says to loosen the tensioner and remove the belt, but something isn't quite right here.
11-24-2007, 11:43 PM #2
- Join Date
- Feb 2007
- Blog Entries
to remove a serpenteine can be done 2 ways....well it's actually one, but you can use two different tools to get it done with. First, you can take a serpenteine belt tool and crank the bolt at the pulley to the left to loosen it temporarily. The other way is to take a socket and ratchet and do the same thing. Don't worry, that bolt is reverse-threaded, so it won't loosen, only tighten when you do this. Good luck!Christopher
1991 Chevy Suburban 1/2 ton 2WD w/ chevy SBC 350-3/4 ton drivetrain upgrade w/4.10 gears 200K miles
2005 Saturn ION-2 Stock 265K miles
1982 Bronco, 1993 Bronco (sold), 1971 M35A2 Deuce and a Half
There are 10 kinds of people, those who understand binary, and those who dont...
Remember kids, the only difference between screwing around and science is writing it down- Adam Savage
11-25-2007, 09:31 AM #3
By rgnprof in forum General Chevy & GM Tech QuestionsReplies: 0Last Post: 06-14-2010, 09:26 PM
By jordan69s in forum Chevy C/K Truck ForumReplies: 3Last Post: 02-14-2010, 12:39 AM
By rfdillon in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 2Last Post: 10-28-2007, 02:50 AM
By rstoomanyhobbies in forum GM PowertrainReplies: 8Last Post: 07-09-2007, 08:57 AM
By 72Blazerod in forum Chevy Tahoe Forum (GMC Yukon, Cadillac Escalade)Replies: 2Last Post: 07-19-2006, 09:31 AM