Results 1 to 6 of 6
05-28-2012, 07:44 PM #1
Spyder Tail Lights collecting dust inside
I have Spyder Tail Lights model #:ALT-YD-CS07-LED-BK
The past two weekends of driving down dirt roads to go camping has caused them to get quite a lot of dust collecting inside, it is very unsightly with the clear lenses and black internal housing of the light. Just thought I would give a heads up to anyone looking at purchasing these in the future.
I am going to attempt to fix this. I might try using a computer air duster through the reverse bulb hole to blow the dust out. Alternatively I may end up using VHT Niteshades to slightly tint them to make it less noticeable. I supose buying a darker lens to begin with would help alleviate this problem, but live and learn I guess.
Does anyone have any other suggestions? Or had a similar problem before? Please post any ideas you have (and don't say buy RECON!)
I will update this thread with any progress I make.
Last edited by UpsetProps; 05-28-2012 at 08:00 PM.
2012 Silverado 1500 LS Crew Cab 4.8L 4x4
- Falken Rocky Mountain ATS 265/70R17, Line-X bed liner, Black Bowties, Stampede front deflector, DeeZee black diamond plate bed rails, TonnoPro Lo-roll cover, Antenna deleted, Spyder Projection Headlights with Phillips CrystalVision Ultra bulbs, Spyder Tail Lights & 3rd Brake Light, Rough Country leveling kit, PlastiDip'd emblems, and wheel hubs, Diablosport Trinity, 20% tint
Next Planned Mods:
Black OEM grill
"Coming through in a new Chevy, droppin' game like it's too heavy."
05-28-2012, 09:02 PM #2
That could happen if the bulbs are not secure, such as the backup bulb. I would clean them out and make sure the seal is tight. If it still happens then I would put an extra layer of sealant on the aftermarket tails.
05-28-2012, 09:22 PM #3
I checked and the reverse is tight. The connection to the LED portion is not sealed at all though. The wires just come out of the hole where the bulb would go if they didn't have the strip of LEDs. When I take it off to clean I will snap a picture of the inside.
05-28-2012, 09:35 PM #4
yes I would check areas where the bulbs would go into to see if there are any gaps that would allow dust to get in like you have pictured. When you examine the light check for any other areas that may contribute to your issue. Could there be gap in the sealant for the lens?
05-28-2012, 09:48 PM #5
My Led taillights actually have a dummy fitting that goes into the open hole that no longer has a bulb in it. the wires run through the dummy fitting so maybe you can get a socket and mod it to allow the wires to run through and seal it up. Sounds like spyder overlooked this issue. I just removed my taillights to put in led reverse bulb and it was pretty dirty behind them but inside the housing itself is still clean. Good luck!!
2011 Silverado CrewCab 5.3L*Ram Air Look Cowl Induction Reflexxion Hood*6" Pro Comp Lift*Flowmaster Dual exhaust*Perfect Launch Rear Diff. Cover*Led Smoke Taillights*L.E.D.Smoke 3rd Brakelight*60" L.E.D. Tailgate Bar*Rearview Mirror Reverse Camera and Sensors*Smoke Headlight Covers*Front Bumper Grill Insert*Deezee Black Alum. Diamond Rail covers*20" Ultra Motorsports Rims wrapped with 35.5"B.F. Goodrich Tires*Inchannel Raingaurds*CAI*Bullydog GT Tuner*Alpine Amp*Boss 6x9's*Boston Acoustic Subs*Terrantula Tweeters*Custom Sub box*Red Led Interior Accents*5% Ultimacool duo tint rear window and doors, 20% front doors*Custom Vinyl Graphics*Demolded*Debadged*Painted drums and calipers*
Future Mods Include: Custom Interior Hydrographics, Electronic Rollup Toneau Cover, 4.56 Gears, Painted rear bumper
05-28-2012, 09:50 PM #6
Thanks Phantom, I was also thinking about making a dummy plug as well.
By dslemaire in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last Post: 02-02-2012, 01:27 PM
By Jplindquist in forum Chevy Silverado Forum (GMC Sierra)Replies: 0Last Post: 04-24-2011, 05:06 PM
By Dontlookforme in forum Chevy Truck AccessoriesReplies: 8Last Post: 10-03-2010, 05:19 AM
By ippielb in forum Chevy Truck AccessoriesReplies: 5Last Post: 07-10-2009, 12:50 PM
By martone68 in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 4Last Post: 03-12-2006, 08:02 AM