Results 1 to 2 of 2
Thread: Help needed for start up.
06-06-2012, 02:29 AM #1
- Join Date
- Feb 2012
- Blog Entries
Help needed for start up.
So i drive a GMC suburban from 1996. Two days ago the truck strated like it should. Yesterday the engine was turning over but he diddent want to fire up. I have gas on the engine but i noticed when i pulled out a spark plug that i have a weak egnition. So i tried with the help of a friend to change the coil and ICM. I just took the coil and ICM of my friends truck and putted it in to mine to see if the problem whas fixt with this or not. Well it is not. I have a scantool and it gives me the codes P0420 and P0430. That is catalyst system efficiency below thershold (bank 1 and bank 2). I have a leak on the exhaust on bank one and i only have one cat so i think that would be the triger for those codes. But can this be the reason the engine dont start? Can sombody help me to a direction what to do now???? HELPlife sucks, but i love it!!!!
06-06-2012, 07:27 AM #2
Look for 55 to 60 PSI from the fuel pump to be sure it is sufficient. Try putting some fuel or starter fluid in the intake and see if it starts for a few seconds. If it does, then start looking for a fuel delivery problem.2000 GMC YUKON SLT, 5.3L tow pkg, G80 rear/w 3.73 gear
By timhall1787 in forum General Chevy & GM Tech QuestionsReplies: 4Last Post: 09-29-2011, 10:00 AM
By rowekmr in forum GM PowertrainReplies: 1Last Post: 01-04-2011, 03:01 AM
By 92'Jimmy in forum Chevy Blazer Forum (GMC Jimmy)Replies: 2Last Post: 11-14-2009, 01:22 AM
By bmxr123 in forum Chevy Silverado Forum (GMC Sierra)Replies: 1Last Post: 07-03-2009, 09:48 AM
By GM_Guy in forum The Coffee Shop ~ Chit ChatReplies: 2Last Post: 08-30-2007, 09:36 AM