Results 1 to 1 of 1
06-11-2012, 07:43 PM #1
- Join Date
- May 2012
- Twin Cities
P0141 - replaced sensor, still getting error code.
Replace the drivers side, downstream O2 sensor today after getting the P0141 error code on my 2000 Suburban (5.3). Disconnected the battery for a few minutes, started the truck, and the SES light is still on. Felt the sensor with the truck running and it was barely warm.
One thing about the sensor - it's an AC Delco that I got on clearance at Rock Auto. Physically it looked like the right replacement (same threads, same hex size) but the electrical connector had 2 plastic tabs inside of it (to make sure it connects the right way) whereas the old connector only had one. Because of the extra tab it did not fit. I ended up popping out the pins and swapping the connectors.
Anyone ever experience this with their new O2 sensor? What should I look at next?
By vulcania in forum GM PowertrainReplies: 4Last Post: 10-07-2011, 01:37 PM
By L0sts0ul in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 1Last Post: 12-01-2010, 07:42 PM
By baszkopiec in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 9Last Post: 08-15-2010, 07:47 PM
By vemery1994 in forum General Chevy & GM Tech QuestionsReplies: 3Last Post: 10-04-2009, 03:33 PM
By jimbo in forum Chevy Suburban Forum (GMC Yukon XL)Replies: 5Last Post: 10-16-2007, 03:38 AM
Tags for this Thread