GM Truck Club
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 8 of 8
  1. #1

    Default Is it possible for me to get my Chevy's front end looking like this?

    Last edited by Mazer18; 02-01-2011 at 06:49 AM.

  2. #2


    I think it's possible, I've been in the 1500, 2500 and 3500, so I'll have a closer look when I see them together again. There isn't anything dramatically different about the front clip between them I don't think.

    10 Chevy Traverse LT AWD
    02 Chevy Trailblazer LS (110K+ miles - loaded except for 4WD - WRECKED!)
    99 Chevy Cavalier LS (105K+ miles - commuter car)
    78 Chevy Suburban Silverado (454, 3/4 ton)
    62 GMC 3/4 ton Pickup (350 police interceptor)

    Remember: Search Before Posting | Fill out Your Profile & Signature
    Follow Us Please: |
    Support GMTC: Help the site, contribute today

  3. #3


    I doubt anyones done this swap yet.
    Get the tape measure out and start taking measurements, check part numbers and compare with the part numbers on your front end.

  4. #4


    I don't think it will work, not at least without replacing the front bumper as well. If you look at the measurement, on the front, just under the headlamp assembly on the 1500, the offset from the bumper and the piece under the headlamp is about 1in. On the 2500, its about 3 inches. The 2500 is up higher off the ground. The middle bumper part sits lower, so the grill is taller, and the side piece under the headlights makes up the diffrence.

    Did that make sense?

  5. #5


    Ok, visuals! The distance from the top of the flare bumper/headlight assembly, to the top of the center bumper on the 1500 is about 1 in-

    The distance on the same parts for the 2500 looks to be about 3 inches-

  6. #6


    I'd compare the part numbers for the headlight assembly, they look a lot alike. That would be a good place start.

  7. #7


    The top of the 2500 grille also looks different. I would stick with like models. I would replace just the grille and see how you like it.
    2008 Silverado_ Gone
    2006 HHR LT
    2008 Cobalt LT
    2001 Sonoma Gone
    2009 Cobalt XFE

  8. #8


    You might be able to combine the horizontol chrome bumper with your endcaps and an aftermarket replacement grill designed for the WT trucks. The end caps are paintable so you can pain them to match or leave them black.

Similar Threads

  1. new to Chevy's
    By surfacewarrior in forum Member Introductions
    Replies: 7
    Last Post: 05-03-2010, 09:07 PM
  2. Chew an Chevy's FS thread
    By ChewNchevys in forum General Classifieds
    Replies: 7
    Last Post: 12-15-2008, 09:09 PM
  3. Chevy's Chrome Bull Bars
    By gumbo2000 in forum Chevy Silverado Forum (GMC Sierra)
    Replies: 2
    Last Post: 06-24-2008, 12:46 PM
  4. New to the site and to Chevy's
    By sheep in forum Member Introductions
    Replies: 9
    Last Post: 04-14-2008, 04:43 PM
  5. Chevy's Elite Nine: How Our Drivers got to the Chase
    By Steve in forum The Coffee Shop ~ Chit Chat
    Replies: 0
    Last Post: 09-10-2007, 12:04 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts