Results 1 to 1 of 1
12-19-2007, 07:17 PM #1
A buddy and I just finished some work on my vehicle. We replaced the following:l/r axle seal, l/r axle bearing, rear brake shoes, l/r wheel cylinder, brake hardware, gear oil, diff cover gasket, brake fluid, turned drums, new tranny kit, rear tranny seal, rear pinion seal valce cover gaskets, power steering pump, drive belt, m/c, brake reservoir, and flushed brake fluid.
When the work was completed, I noticed that when I accelerate past 40, the vehicle vibrates. It feels like I am driving over small speed bumps. We cannot figure out what is causing this. Does anyone have a clue? Thanks.'96 Suburban 1500 5.7
Capitalism is the legitimate racket of the ruling class.
By Z-71 in forum Chevy Silverado Forum (GMC Sierra)Replies: 17Last Post: 02-10-2012, 05:23 PM
By Pirate in forum GM PowertrainReplies: 5Last Post: 12-24-2009, 12:03 AM
By 88stepside in forum GM PowertrainReplies: 0Last Post: 11-29-2009, 12:44 PM
By CornhuskerChevy in forum Audio, Video & Gadget TechReplies: 2Last Post: 08-09-2009, 09:35 PM
By jdog468 in forum General Chevy & GM Tech QuestionsReplies: 7Last Post: 02-26-2009, 10:08 AM
Tags for this Thread