GM Truck Club
THE PREMIER CHEVY TRUCK & SUV FORUM
Founded in 2004 ~ We're the #1 Chevy Truck & SUV Forum.
Silverado & Sierra | Tahoe & Yukon | Suburban & Yukon XL | SUV & CROSSOVER
Results 1 to 4 of 4

Thread: CEL Code

  1. #1
    Jr. Apprentice
    Join Date
    Mar 2009
    Location
    Edgerton, OH
    Posts
    22

    Default CEL Code

    The CEL is on. I have a 1997 K1500 Silverado. The code is P1345 "Manufacturer Control Ignition System or Misfire". Odd thing is it seens to run fine. Any thought as to what I should look into for the problem? FYI I tried clearing the code to see if i would come back and it does just a few seconds after start up.
    1997 K1500 Silverado 5.7L
    1985 MB 300D 'Margaret' 253,000 miles
    1985 MB 300D California version 'Maybellene' 268,000 miles (death by deer at high speed)
    1981 MB 300D 'Madeline' 238,000 miles
    1991 MB 300SE 'Alarice' 158,000 miles

  2. #2

    Default

    As I understand it, P1xxx codes are often manufacturer specific, so, to get a good code definition you need a source that knows GM codes, not just generic codes.

    That said, it has been a while since I've seen it, but it seems like P1345 was the code that points to the "timing" being off (or some other fault inside the distributor).

    Have you recently done any work on the distributor or work that required removing the distributor? If so, this usually indicates that you didn't get the distributor back on in exactly the right position. Get a high end scanner (one that can read the cam retard parameter) and adjust the distributor until cam retard is 0 +/- 2 degrees.

    If there hasn't been any recent work that would throw the timing off, then you can check the timing, but it might be indicating some failure or pending in the distributor. If a tune up is due, it might be worth the time to get the tune up out of the way.
    '98 K1500 Suburban LS 5.7 L 4L60E NV246 ARB
    '92 Ford Explorer XLT 4x4 4.0 L A4LD BW13-54 Trac-loc rear
    "My toys were the greasy cogs and springs and pistons that lay around all over the place, and these, I can promise you, were far more fun to play with than most of the plastic rubbish children are given nowadays." Danny in Roald Dahl's Danny The Champion of the World

  3. #3
    Jr. Apprentice
    Join Date
    Mar 2009
    Location
    Edgerton, OH
    Posts
    22

    Default

    I have not touched this engine. I will Google the code. Is there a site for that?
    1997 K1500 Silverado 5.7L
    1985 MB 300D 'Margaret' 253,000 miles
    1985 MB 300D California version 'Maybellene' 268,000 miles (death by deer at high speed)
    1981 MB 300D 'Madeline' 238,000 miles
    1991 MB 300SE 'Alarice' 158,000 miles

  4. #4

    Default

    I haven't found a good website with manufacturer specific codes. Best sources for information on code diagnosis I have found is a good repair manual (I find that many libraries have these manuals, some have subscriptions to online manuals for their patrons). You might also put the code number into this site's search engine, as I'm almost certain we have discussed it here before.
    '98 K1500 Suburban LS 5.7 L 4L60E NV246 ARB
    '92 Ford Explorer XLT 4x4 4.0 L A4LD BW13-54 Trac-loc rear
    "My toys were the greasy cogs and springs and pistons that lay around all over the place, and these, I can promise you, were far more fun to play with than most of the plastic rubbish children are given nowadays." Danny in Roald Dahl's Danny The Champion of the World

Similar Threads

  1. code help
    By luvit4it in forum Chevy Truck Tech Forum
    Replies: 2
    Last Post: 11-09-2011, 11:05 AM
  2. PCM Code Help
    By Dirtysailor in forum GM Powertrain
    Replies: 7
    Last Post: 09-30-2010, 02:03 PM
  3. 1998 Chevrolet Silverado 5.7 Code p0340 code help
    By campuscop2003 in forum GM Powertrain
    Replies: 3
    Last Post: 08-06-2010, 10:08 PM
  4. Help with code.....
    By Oscarvan in forum Chevy Suburban Forum (GMC Yukon XL)
    Replies: 7
    Last Post: 02-08-2010, 07:49 AM
  5. L31 RPO Code???
    By TrailFiend in forum GM Powertrain
    Replies: 2
    Last Post: 12-31-2007, 08:11 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •