Results 1 to 9 of 9
08-28-2012, 04:05 PM #1
If you had multiple issues, would you go to the stealership and have them diagnose it
I personally dislike the attitude and over priced parts and labor that my local stealership charges but I have a number of issues that need to be looked at and the stealership told me to bring a punch list of everything I want them to look at. The diagnostic fee is $130 to diagnose everything.
If I choose to have the stealership repair any of the problems, the $130 will go toward the repairs. If I do not let them fix the issues, then I am out the $130.
So far my punch list is:
- Locate and price the repair of all oil leaks (Headers, value covers, oil pan gasket)
- replace the lifters and springs ( the tick noise, typically when it is cold out side )
- determine why I am getting white smoke out the exhaust when the truck has been idling for 10 minutes or more. (The 5.3L has issues with coolant getting in one or more of the piston heads ) Not sure if this is my issue, but have them look into it.
- Figure out why the power locks stopped working ( no it is not the battery in the key fob, the fuses or relays) already checked those.
- Potentially replace the water pump ( still original ) 216k on the odometer.
- Replace the fuel injectors (8 of them)
- Fix my e-brake because it is too loose even after using the adjuster under the truck (there are TSB's on this, but I am out of warranty)
- Install new front left and right wheel hubs.
I am thinking it might be worth it to have them connect the Tech 2, give me a full diagnosis and eat the $130 and then have the work done by a recommended mechanic outside the stealership. This way I know what needs to be done.
What do you think?
Last edited by PantheraUncia; 08-28-2012 at 04:05 PM. Reason: Add more information
08-28-2012, 04:15 PM #2
- Join Date
- Dec 2011
- Blog Entries
Call your normal better priced mechanic and ask him his price and do same at dealer. Also fix what you can on your own to save $$$
1996 Chevy Tahoe LT 5.7L V8 4X4 205,000+ miles. Built proudly at Janesville Assembly in Janesville, Wisconsin
Basic mods: Lights all over, bunch of electrical work, and a couple cooling mods.
Check out my other mods in My Garage: http://www.gmtruckclub.com/forum/sho...t-Tahoe-4-Door
08-28-2012, 05:39 PM #3
I have the stealership do only what they absolutely have to do. For example, I recently took the truck in to have an overtravel condition programmatically dealt with in the HVAC control unit ... something only they could fix. Anything that can be done by me or a mechanic I trust completely ... is done by me or that mechanic, not the stealership.
08-28-2012, 06:51 PM #4
They are going to love to see you.
Would you give me a little more detail on some of your needs?
Like, why do you think the injectors should be changed?
Why do you have the water pump on the list?
The lifters and springs are an expensive change, did you try an additives that are reputed to clean lifters (lifters will tick if they have a little dirt stuck inside)
Why new front hubs?
The price for that amount of work might exceed the value of the truck.Ray
'09 Avalanche LTZ - Black
'05 Envoy XL (sold)
08-28-2012, 10:55 PM #5
The front drivers side wheel hub has a little play in it, but it is not bad yet. I park in a parking deck so I end up making an extra 6 right and left turns every day that most people don't have to deal with, over 12 years, it adds up.
08-29-2012, 03:07 AM #6
Injectors have a life expectancy of 1 billion cycles. Yes they can fail, but with proper filter maintenance and using high quality gas, they should last the life of the vehicle. Injectors can have carbon build-up, this can be removed with a little interstate driving and/or adding, something like Seafoam. They can also wear, but if the mileage is good and there are no starting problems, the wear is probably not a problem.Ray
'09 Avalanche LTZ - Black
'05 Envoy XL (sold)
08-29-2012, 10:59 AM #7
- Join Date
- Mar 2006
- Cameron, NC
- Blog Entries
Let me address these one by one...
1. Locate and price the repair of all oil leaks (Headers, value covers, oil pan gasket)
2. replace the lifters and springs ( the tick noise, typically when it is cold out side )
3. determine why I am getting white smoke out the exhaust when the truck has been idling for 10 minutes or more. (The 5.3L has issues with coolant getting in one or more of the piston heads ) Not sure if this is my issue, but have them look into it.
4. Figure out why the power locks stopped working ( no it is not the battery in the key fob, the fuses or relays) already checked those.
5. Potentially replace the water pump ( still original ) 216k on the odometer.
6. Replace the fuel injectors (8 of them)
7. Fix my e-brake because it is too loose even after using the adjuster under the truck (there are TSB's on this, but I am out of warranty)
7. Install new front left and right wheel hubs.
here is my nickel's worth of free advice... You have a truck with 216,000 miles on it. It doesn't make any sense to go dumping a bunch of money into an engine with that many miles on it. (Especially when there isn't really anything wrong with it... yet.) A head job alone would cost you over a thousand dollars. Then you would have a 216,000 mile half-worn-out engine with new heads. With the cost of everything you have listed on here, you could buy a new crate engine! At the very least, you could buy a low mileage engine from the junk yard for just the cost of the head job.
Replacing parts that are not bad is like taking a bunch of prescription meds to treat health problems you don't have but might get in the future. All you are doing is guessing what might break in the near future and replacing parts... based on what? What happens if you spend all of this money and 2 months later the AC quits, the fuel pump goes out, the radiator starts leaking, the oil pump fails and your engine locks up, the timing chain breaks and bends all of the valves in your new heads (Happened to a friend of mine 6 months ago after doing a head job on his 454), the transmission starts slipping... If you are eager to spend money fixing things, just be patient! You will have your opportunity sooner or later!
Last edited by moogvo; 08-29-2012 at 11:14 AM."It went together didn't it? Well then there has to be a way to take it apart!" - Me.
Check out my image gallery HERE.
"The true measure of a man is how he treats someone who can do him absolutely no good." ~Samuel Johnson (1709-1784)
08-29-2012, 11:59 AM #8
I tend to agree with moog: fix only what is broken ... as it breaks ... unless it makes more cash sense to do a full replacement. (Also, look upon each such breakage as an opportunity to do an upgrade!)
If you've got leaks ... fix them with new seals. If, like me, you have to drop the transmission to fix something in its guts, THEN is when it might make sense to replace or rebuild the whole unit ... but not until you run into a problem like that. The same thinking should really be applied to the engine; if you throw a rod ... then maybe it's time to overhaul the engine, but beyond major issues, fix what little you can. You get the idea.
09-03-2012, 03:16 AM #9
While not nearly as knowledgeable as Moog or Surreal I nonetheless agree with what they're saying. I tend to take my truck into the dealership for even minor possible issues right now, but that's because A) I'm in Afghanistan so actually my wife is taking it B) I and my family has a relationship with many of the people in the service department and I deal with specific people, and MOST IMPORTANTLY (C) it's still under warranty so I want my money's worth. Once it's out of warranty, A) will no longer apply and B) matters less to me when it comes down to cost. (Basically, that long relationship means I trust them to do the work correctly, not that I trust them to do it in the most cost-effective manner.)
My truck also only has about a quarter of the mileage yours does. Once I get to the point you're at I'm hoping it's running well and I plan to give it to my son for his first car. At that point it's his problem.
If it starts breaking before that point, I'll really have to decide whether to fix it or buy something else. We shall see...
To Be Completed (Eventually):
6" BDS Suspension lift | KingShocks Front and Rear Coil Overs | 4.56 Gears | 35" A/Ts (TBD) | Cervinis 07-12 Silverado Ram Air Hood | Fab Fours Front Winch Bumper (CS07-H2051-1) | Fab Fours Full Size Rear Bumper (CS07-W1850-1) | RX-2 Series Main Grille (Black) | Line-x Bed and wheel wells | Skid Plates | Rizor Automated Tonneau Cover | Custom Bed Insert | RBP RX-3 Series Nerf Bars | Kenwood Excelon DNX9990HD | JL Audio Stealthbox (2x500RMS) | JL Audio HD 1200/1 Class D Mono Amp | JL Audio C5-653 Components (Front) | JL Audio C5-650 Components (Rear) | JL Audio Slash v2 300/4v2 Class A/B Amp
By bigdave367 in forum Performance & FuelReplies: 1Last Post: 10-25-2011, 05:51 AM
By bigdave367 in forum GM PowertrainReplies: 1Last Post: 10-24-2011, 04:09 PM
By chuckwagon in forum Lifted & Offroad SuspensionReplies: 14Last Post: 09-22-2010, 07:38 PM
By Dr_Zero in forum Audio, Video & Gadget TechReplies: 5Last Post: 01-25-2009, 10:18 AM
By Steve in forum Product ReviewsReplies: 8Last Post: 02-12-2008, 07:31 PM
Tags for this Thread