Results 11 to 12 of 12
09-13-2012, 09:44 AM #11
To Stop the Automatic Door Locks from Engaging, this is done, as mentioned above through DIC, by doing the following,
AUTO DOOR UNLOCK..... This feature allows you to select whether or not to turn off the Automatic Door Unlocking Feature. It also allows you to select which Doors and when the Doors will Automatically Unlock.
....Press the Customization Button until AUTO DOOR UNLOCK appears on the DIC Display:
***Press the Set/Reset Button once to access the settings for this feature.
***Then Press the Customization Button to Scroll through the following settings:
***OFF: None of the Doors will Automatically Unlock.
***DRIVER AT KEY OUT: Only the Driverís Door will Unlock when the key is taken out of the Ignition.
***DRIVER IN PARK: Only the Driverís Door will unlock when the Vehicle is shifted into P (Park).
***ALL AT KEY OUT: All of the Doors will Unlock when the Key is taken out of the Ignition.
***ALL IN PARK (default): All of the Doors will Unlock when the Vehicle is shifted into P (Park).
***NO CHANGE: No change will be made to this feature. The current setting will remain.
***To Select a Setting, Press the Set/Reset Button while the desired Setting is Displayed on the DIC.
5.3 l 3.73 l G80
BLACK BEAR CUSTOM TUNE
SNUGTOP l COLORMATCH l KATZKIN
09-13-2012, 10:34 AM #12
If you know someone with a GM Tech 2 or MDI programmer, they should be able to shut it off..... A dealer would too, but its a safety issue so I am sure the dealer would not do it if you asked them, they would be liable if you went through the windshield because the warning was cut off.
By sierra2nv in forum Chevy Truck Tech ForumReplies: 0Last Post: 06-01-2011, 03:13 PM
By BillNH in forum Chevy Truck AccessoriesReplies: 8Last Post: 12-20-2009, 03:53 PM
By BillNH in forum General Chevy & GM Tech QuestionsReplies: 1Last Post: 12-15-2009, 10:58 PM
By hyperkiper11 in forum Chevy Colorado Forum (GMC Canyon)Replies: 0Last Post: 02-01-2009, 01:54 PM
By zdogefizzle in forum General Chevy & GM Tech QuestionsReplies: 6Last Post: 05-20-2008, 10:47 PM
Tags for this Thread