1996 Suburban Starter

Discussion in 'Chevy Suburban Forum (GMC Yukon XL)' started by kjhooper2007, Jan 21, 2012.

  1. kjhooper2007

    kjhooper2007 New Member

    The starter in my suburban is bad the solenoid is good. I just dont know where to start with changing it out. What is the best way to get at it and change it out. thanks for any info.

    ---------- Post added at 03:52 PM ---------- Previous post was at 03:22 PM ----------

    Forgot the important stuff... 1996 suburban, 2500, 7.4 lt
     
  2. vncj96

    vncj96 Epic Member 5+ Years 1000 Posts

    starters are generally 2 bolts. A long and short one, there is a couple wires that are held on by smaller nuts and a washer, pretty simple, sometimes they are a little tricky depending on where its located on the flywheel. I just recently changes out mine on my 99 silverado and took some manuevring and a few choice words to help it along, but from start to finish was still only a 15 min job!
     

Share This Page

Newest Gallery Photos