1. Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online
    Online since 2004, we are the #1 Chevy Truck & SUV forum and user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free
    Registering is Free and Easy! Hope to see you on the forums soon!

4.3 v6 that wont run right after setting the timing

Discussion in 'Performance & Fuel' started by Jmac527, Oct 20, 2012.

  1. Jmac527

    Jmac527 New Member

    I could use some help here. I have a 1990 Chevy truck with a 4.3, one day a few weeks ago the truck just quit and never would restart. I replaced the the distributor module and pick-up coil. Installed new plugs and reset the timing to 0 degrees. I know that the tan and black wire has to be disconnected to set the timing. When I re-connect the wire the truck won't stay running and starts back-firing at upper rpm... The truck has an Edelbrock PROM chip installed as well, it was free with the Edelbrock intake and cam. I've reset the timing and checked my entire ignition system. This is my only transportation and I need to get this truck going... what do ya think????

Share This Page