4.3L rebuild Info?

Discussion in 'Chevy Blazer Forum (GMC Jimmy)' started by M.Filli, Feb 21, 2012.

  1. M.Filli

    M.Filli New Member

    Doing a very basic rebuild on a 98' GM 4.3L, was wondering if anyone could share some tech info from there manual, looking for main and rod bearing torque procedure, and head and intake torque procedure. Would sure like to not buy a manual and save some beer money.

    98' olds bravada/blazer, bought cheap, not running, sitting for few years, rusted fuel tank, failed fuel pump, engine oil mud, lifter failure, pushrod damaged, misfire code, runs rough, failed fuel pressure regulator, 105,000 miles, Pulled engine, swamp out muck, clean and inspect, reusing all but lifter/pushrod/gaskets, on the right track?

Share This Page

Newest Gallery Photos