79 scottsdale carb problems?

Discussion in 'Chevy C/K Truck Forum' started by chazawazzle, Mar 17, 2010.

  1. chazawazzle

    chazawazzle New Member

    i think my fuel air mixture is messed up on my 600 edelbrock. any advice on screw position?
     
  2. chazawazzle

    chazawazzle New Member

    anyone? cmon i need help here.
     
  3. RWK

    RWK Rockstar

    I'm not sure on the Edelbrock, but on a regular Chevy Carb. I was told to put the screws all the way in and back it off 1 & 1/2 turns.

    When I brought my truck in for a professional tune up, they said nothing needed to be adjusted on the carb.
     
  4. 71k-10

    71k-10 New Member

    That should get you going, at least in the ballpark!
     
  5. dannys99

    dannys99 Rockstar

    Turn M in then out 1.5 turns, then go and smell the exhhuast for 30 seconds if your eyes are bloodshot after that then turn M out another 1/2 turn. usually when it runs smooth at about 800 rpm you got them close.
     

Share This Page

Newest Gallery Photos