85' no voltage to choke

Discussion in 'GM Electrical Tech' started by clemertime, Jan 20, 2010.

  1. clemertime

    clemertime New Member

    I have a 1985 C10 - 5.0 the choke and the throttle position switch do not have any voltage to them. Check the fuse block and the fuses are OK. Any suggestions?
     
  2. bigburb

    bigburb Rockstar ROTM Winner 100 Posts

    I don't have much experience with the older models, but I thought the choke and throttle was all mechanical? It looks like I'm wrong but I thought they didn't switch to that until '87...

    But anyway since it's your truck and I probably don't know what I'm talking about, I would start by checking the grounds. That's the easiest and cheapest way.
     
  3. clemertime

    clemertime New Member

    I tried tracing back as far as I could see where the wire ends up.
    I'm not sure if they are in part of the ECM or not.
     

Share This Page

Newest Gallery Photos