1. Chevy Truck Forum

    Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online

    Online since 2004, we're the #1 Chevy Truck & SUV user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free

    Registering is Free and Easy! Do it today and we'll see you on the forums soon!

93 suburban wiper motor

Discussion in 'Audio, Video & Gadget Tech' started by GRIFF, Mar 22, 2008.

  1. GRIFF

    GRIFF New Member

    Any tips on how to replace this, they worked last night it snowed throughout the night went to turn them on and they tried to work and then worked on high for about 10 swipes niow they they just bump when the switch is hit. The motor is hot so I dont think it is the switch.
     
  2. 95CTburb19

    95CTburb19 Epic Member 5+ Years 1000 Posts

    this happened to me a couple months ago. try pouring some hot water down the grate in front of the windshield. It doesn't have to be boiling or anything just decently warm. It worked for me.
     
  3. GRIFF

    GRIFF New Member

    It was the motor it smelled burnt.. It is a fairly easy job. You need to remove the wipers by pulling them up like you are going to change the blades there is a small tab where the wipers slide down on the shaft, pull it out and wiggle the wpier assembly off. Next unbolt the cowl cover thing it is three pieces you will see the wiper moter connection to the assembly that moves the wiper try to mark this so it goes back on the same way unbolt and remove(I screwed up and didnt mark it) unplug and unbolt the wiper motor assembly(10 mm screws) you need to reuse the grommets off the old motor(at least with the one I had) and the rubber shield that goes between the wiper motor and the firwewall. Basically do it all in reverse to put it back together about a 1.5 hour job easy and about $55 in parts.
     

Share This Page