i purchased my truck with a set of aftermarket flat aluminum running boards. (well the rear quarter of the running board is somewhat tilted upward) its not truly noticable,but i notice it,and its really itchin at me :cry: was wondering if i could get a 2x4 or something in that realm to level it back out and sorta hammer it back straight without taking the whole board off? (the boards have like 3 pegs underneath that bolt in to the chassis. i thought that probably one of the pegs were bent, but all of them are straight. so it seems all that was harmed was the board itself. can someone share me some light on this ?