Blower resistor problem

Discussion in 'General Chevy & GM Tech Questions' started by tsbichler, Nov 16, 2010.

  1. tsbichler

    tsbichler New Member

    Hi
    I just replaced blower resistor & harness on my 05' chevy 1500. After installing, vent selector switch no longer works. Stuck on defrost / floor combo. I thought I was carefull to match up wires from old harness to new, but possible I messed up. Is there anything else that would cause this to happen? I matched colors and location on connector, or so I thought!


    Thank you!
     
  2. Dontlookforme

    Dontlookforme Rockstar

    Im not 100% sure but i think this might be a separate problem...... the air selector is under the dash on the driver side. Your blower motor works? Sounds like it could be the air vent door actuator.
     

Share This Page

Newest Gallery Photos