1. Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online
    Online since 2004, we are the #1 Chevy Truck & SUV forum and user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free
    Registering is Free and Easy! Hope to see you on the forums soon!

Chevy Suburban Keyless Remotes and Remote Programming

Discussion in 'Chevy Keyless Entry Remotes' started by ChevyFan, Jul 29, 2007.

  1. ChevyFan

    ChevyFan Administrator Staff Member 1000 Posts

    2005 Chevy Suburban Keyless Entry Remote fob programming instructons

    1. Close all vehicle doors.
    2. Insert the key into the ignition.
    3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold down until instructed
    to release in step 9.

    4. Perform steps 5 through 8 in fairly rapid succession.
    5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).
    6. Turn the ignition switch to the OFF position.
    7. Turn the ignition switch to the ON position.
    8. Turn the ignition switch to the OFF position.
    9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.
    10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the door locks and unlocks.
    This step may take up to 30 seconds.

    11. Repeat step 10 NOW for each additional transmitter (including any existing transmitters).
    12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode.
  2. FireRed

    FireRed New Member 100 Posts

    Thanks for the programing, it worked like a charm!

    Phil
  3. JayMack75

    JayMack75 Former Member

    Do you think this will work with a 99 Silverado? My uncle dropped my remote in the toilet, luckily the battery was dead.
  4. FireRed

    FireRed New Member 100 Posts

    Do you if it has roaming code like the late ones? It may be like my 97, try holding the remote close to the vehicle then press & hold both lock & unlock buttons at the same time for about 30 seconds.

    Phil
  5. artnash08

    artnash08 New Member

    Following your instructions to reprogram the keyless entry for a 2002 Chevy Suburban, I went through all the steps and the door locks recycled after step 10. However, the keyless entry still would not work. Any suggestions?

    Thanks

Share This Page