DIY headlight turn signal system,

Discussion in 'Chevy Truck Accessories' started by DJTricky, May 4, 2008.

  1. DJTricky

    DJTricky Rockstar

    some of you have seen my "blue" headlights, well there not totally blue, there also not just my headlights. there my turn signals as well. if you would like to learn how to do this just ask.

    [​IMG]
    [​IMG]

    headlights on
    [​IMG]


    [​IMG]
     
  2. zach45

    zach45 Epic Member 5+ Years 100 Posts

    that looks really good man...

    good job
     
  3. DJTricky

    DJTricky Rockstar

    if your wondering how to do it i can tell you, its really easy and cheap for a one off look.
     
  4. GoFastPadre

    GoFastPadre Rockstar 100 Posts

    I for 1 would like to know, looks great!
     
  5. DJTricky

    DJTricky Rockstar

    needed stuff
    - 4 5mm LED's ( http://www.oznium.com/led )
    - 3 or 4 feet of wire
    - electric drill and bits
    and epoxy or silicone rubber



    1. remove your grille. and locate turn signal wires

    2. take the drill and appropriate size bit. and put one hole in each headlight chamber (4 holes in total)

    3. insert one led in each hole and glue in using the silicone rubber or epoxy

    4. run the positive and negative the the right wires, you might have to play around with the combination to get the effect that you want. but the black will be the negative

    5. splice then together (led wires and turn signals)

    6 and then put your grille back on and step back at your new glow.
     

Share This Page

Newest Gallery Photos