1. Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online
    Online since 2004, we are the #1 Chevy Truck & SUV forum and user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free
    Registering is Free and Easy! Hope to see you on the forums soon!

Do we need to Clear Codes on a Transfer Case and Actuator?

Discussion in 'General Chevy & GM Tech Questions' started by derickheggie, Feb 5, 2011.

  1. derickheggie

    derickheggie New Member

    I just installed a newly rebuilt transfer case and actuator motor (actuator motor was used). Everything is buttoned up and ready to go, but we are getting a code thrown to us in the dash.

    Service 4wd (This is what shows up in the dash)

    When I turn the key the push button 4wd lights momentarily light up, but then shut off.

    Now i have heard from others that we need to re-code the motor, in a sense wipe it clean? I have heard we need to push and hold 2 buttons, and then push down another button and that shifts it into neutral, and that should be it, but it is not working, or maybe we are doing it wrong?

    So,
    do I need to connect a coder to the computer?
    What is the correct process for the button pressing?

    Any help would be greatly appreciated!

    2003 Silverado, 6.0L
    New process Transfer Case, Model 246

Share This Page