1. Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online
    Online since 2004, we are the #1 Chevy Truck & SUV forum and user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free
    Registering is Free and Easy! Hope to see you on the forums soon!

even bank not firing???

Discussion in 'General Chevy & GM Tech Questions' started by 505090, Aug 19, 2010.

  1. 505090

    505090 New Member

    I have a 77 small block 350 I am fixing for a friend. At this point I am trying to adjust the carb (4 barrel rochester). RPM is at ~800 and I am adjusting the two mixture screws on the front base using a vaccum gauge. My problem is the right bank is setting to ~4 turns out and the left is setting to ~.5 In the past when I've done this both sides have been in close proximity to each other. Not sure what the problem is or what would cause it.

    Any ideas appreciated, thanks for your time.
  2. Taylornutranch

    Taylornutranch New Member

    Buy a holley. Those stink to rebuild, and that sounds like the problem.

Share This Page