help with rear drive shaft flange

Discussion in 'GM Powertrain' started by colton05, Feb 22, 2010.

  1. colton05

    colton05 New Member

    Hi, I have a 1988 Suburban 4x4 with 3/4 ton axles. The rear pinion seal went out on me. I already got the drive shaft and nut off but the flange will not come off for nothing. I've already snapped a jaw on a 5 ton three jaw puller. Any advice would be greatly appreciated. Thanks in advance.
     
  2. Jimmiee

    Jimmiee Epic Member 5+ Years 1000 Posts

    You need a puller that clamps around the flange and then a big C Clamp to keep the puller jaws from sliding off the flange. Those yokes can rust on pretty tight.
     

Share This Page

Newest Gallery Photos