Keyfob question

Discussion in 'Chevy Truck Accessories' started by Blazerado, Jun 12, 2011.

  1. Blazerado

    Blazerado Rockstar 100 Posts

    Is there anyway if i buy a new keyfob for my 04 1500 that i can program it myself and not have to pay the dealer.
     
  2. redneck70

    redneck70 Rockstar

    Yep, follow this and you should be good to go.

    1. Close all vehicle doors.

    2. Insert the key into the ignition.
    3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold
    down until instructed to release in step 9.
    4. Perform steps 5 through 8 in fairly rapid succession.
    5. Turn the ignition switch to the ON position (as far as you can go without starting the
    engine).
    6. Turn the ignition switch to the OFF position.
    7. Turn the ignition switch to the ON position.
    8. Turn the ignition switch to the OFF position.
    9. Release the power unlock button on the door panel. The vehicle will lock and unlock
    the doors automatically.
    10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until
    the door locks and unlocks.
    This step may take up to 30 seconds.
    11. Repeat step 10 NOW for each additional transmitter (including any existing
    transmitters).
    12. Turn the ignition switch to the ON position in order to exit the transmitter programming
    mode.
     

Share This Page

Newest Gallery Photos