1. Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online
    Online since 2004, we are the #1 Chevy Truck & SUV forum and user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free
    Registering is Free and Easy! Hope to see you on the forums soon!

Need Help and Quick!!! 90 Chevy Won't Start

Discussion in 'Chevy C/K Truck Forum' started by chevyracingss, Sep 22, 2011.

  1. chevyracingss

    chevyracingss New Member

    Hey Guys,

    I have a 1990 K1500 4WD 5-Spd. 5.7L TBI. The Truck Won't Start. It is not spraying fuel from the injectors. There is also no power at the injector connectors. I have tested the connectors and the ICM. Both check out. There is battery voltage at the module from the PCM as well as the ICM checked out according to autozone. I expected it would as The entire distributor is new. Not remanned, New from Rock auto. The distributor is 100% new as well as all the parts on it. (pick-up coil, ICM, cap, rotor, etc.) The Coil is fairly new, less than a year. The fuses are good. What else do I need to check or test.
  2. silveradotrailblazer

    silveradotrailblazer New Member 1000 Posts

    Check your grounds.
  3. BobEhud

    BobEhud New Member

    you are not getting a signal to the system.Get a set of Noid lights and crank the truck if they pulse..(which they shouldn't) id have to be there to figure it out.
    remember no matter how much crap they throw on these trucks they have to have the basics compression,spark and fuel to run.

    The noid lights will tell you if the injectors are getting a signal if they don't you have lost your reference signal.Find your cam and crank sensor and check them ( do not remember how off the top of my head some use voltage with key on,some use ohm resistance,they will give you a range they should fall into)
  4. chevyracingss

    chevyracingss New Member

    Appreciate the help so far. but got the fuel problem fixed. I had to take the rubber boots off of the connectors for the ICM. That fixed the problem with the fuel. However, the truck is still not starting. I had the coil tested and replaced at AZ and that did not resolve the problem. I am still getting fuel now, but no spark. Still troubleshooting. Any other help would be appreciated. Thanks to all

Share This Page