new to the site. need some info on brakes and rotors

Discussion in 'Member Introductions' started by ICECOLDB, Aug 16, 2010.

  1. ICECOLDB

    ICECOLDB New Member

    I am new to this site and looking for info. i just found out my brakes need to be replaced so i am going to replace rotors as well just in case they are bad. want to know what is better cross drilled, slotted or smotth finsh
  2. silveradotrailblazer

    silveradotrailblazer New Member 1000 Posts 100 Posts

    Welcome to the club. For a street truck I prefer the slotted. Drilled rotors get heat cracks around the holes. Race cars use them because the do cool better but they get changed after one or a few races, unlike your street truck that may have them on for years.
  3. Eddie Z71

    Eddie Z71 New Member 1000 Posts 100 Posts

    Hi, and welcome to the site!
  4. murdog94

    murdog94 New Member 1000 Posts 100 Posts

    Welcome aboard.
  5. Big75

    Big75 New Member 100 Posts

    maybe you should have your rotors checked before you start spending cash. unless you're dead set on having neat looking rotors.
  6. Springthing

    Springthing New Member 1000 Posts 100 Posts

    X2...........
  7. KWG08VMI

    KWG08VMI New Member 100 Posts

    Big75 is right, having them checked can save you a lot of cash. Even if you end up just getting them turned, that would be cheaper than a new set.

Share This Page