Parking sensors 2010 GMC Sierra

Discussion in 'GM Electrical Tech' started by rayjuswa, Jan 11, 2011.

  1. rayjuswa

    rayjuswa New Member

    Can someone help me?
    I own a 2010 GMC Sierra 1500 pick up truck
    I plan on installing parking sensors both front and rear
    After searching the internet I think that I finally found what I want.
    Here's the problem
    The rear bumper is indented in the center to accomodate the trailer hitch
    The instalation instructions and video show how to install the sensors on a car
    The measurements don't work for a truck
    Can I move the center sensors closer to the end of the bumper and still expect the system to work properly?
    Do I have to move the outside sensors further out toward the end of the bumper?
    I don't want to start drilling holes in my bumper without knowing that it's going to work
    Ray J
  2. ntbush83

    ntbush83 Epic Member 5+ Years ROTM Winner 1000 Posts

    Welcome to the club!

    Sorry i can't help on this one because I've never installed these. I would say the best thing to do is contact the company who makes the sensor kit because they know the most about their product.

    But hopefully someone on here has installed them!
  3. wayned

    wayned Rockstar 100 Posts

    I installed them in the outside holes in my ranch hand bumper that were predrilled.
    if you walked up to the center they worked until you were about a foot away.
    it was $30.00 for two more sensors, I installed them mostly to have spares.
    psd100 advent sensors from audiovox.

    Last edited: Feb 5, 2011

Share This Page

Newest Gallery Photos