1. Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online
    Online since 2004, we are the #1 Chevy Truck & SUV forum and user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free
    Registering is Free and Easy! Hope to see you on the forums soon!

Remote Programming Instructions 1998 Suburban

Discussion in 'Chevy Suburban Forum (GMC Yukon XL)' started by kevinmeister, Jul 13, 2007.

  1. kevinmeister

    kevinmeister New Member

    Item title: 1998 98 GMC Suburban Remote Programming Instructions


    1. Locate the Data Link Port. It is located under dash drivers side.
    Be sure you
    know which pins are 8 and 4.
    (Notice port is wider on top row)







    2. Make sure there are metal contact pins in terminals 8 and 4. Connect
    8 to 4
    with a suitable jumper wire (leave the jumper wire connected throughout the

    programming procedure). Make sure you know which terminals are 8 and 4. The

    vehicle will respond by locking and unlocking the doors to signify entering
    of
    programming mode.


    3. Press and hold both the LOCK and UNLOCK buttons together on the first

    transmitter to be programmed. After about 15 seconds, the vehicle will respond
    by
    locking and unlocking the doors. Release the buttons on the transmitter.


    4. Within one minute, repeat the previous step on the remaining transmitters
    to
    be programmed.


    5. Remove jumper wire applied to the OBDII Port.
  2. Cableguy

    Cableguy New Member 1000 Posts

    Thanks Kevin! Good work. :great:
  3. wakejim

    wakejim New Member

    Thanks Kevin, I used a paper clip to jump the 2 terminals and it work perfect. Now I have 2 remotes that work again. Thanks for the great info.

Share This Page