1. Welcome To GMTruckClub.com!

    The #1 Chevy Truck Forum Online
    Online since 2004, we are the #1 Chevy Truck & SUV forum and user community. If you have any questions about your Chevy or GMC Truck, SUV or Crossover, or just want to connect with other GM owners and enthusiasts around the world, you've found the best place on the internet to do that.

    Join Today ~ It's Free
    Registering is Free and Easy! Hope to see you on the forums soon!

Replaced Hub Bearing

Discussion in 'Chevy Silverado Forum (GMC Sierra)' started by BowTieFan1, Apr 29, 2011.

  1. BowTieFan1

    BowTieFan1 New Member

    I replaced my hub bearing today on my `04 Silverado. The old bearing had 125,000+ miles on it. The job was not so bad.
    The hardest part was getting the old one out. I sprayed lots of PB Blaster around it, and beat on it with a hammer. After a few minutes it popped right out. There was a lot of rust in the knuckle bore. Cleaned it out with emory paper and a wire wheel brush on a drill and then lightly greased the bore and surfaces.
    The truck rides and steers a lot better now. :great:

Share This Page